ABSTRACT
The work has gone a long way in determining strength of concrete made of various aggregates such as granites stone, black gravel, washed gravel and surface gravel.
Some factors such as porosity of the aggregate temperature causing loss of water plate form for mixing of concrete mix affect the workability and eventually the strength of concrete.
This project work consist of using hydraulic machine to carryout the compressive test of the strength of concrete made of the earlier mentioned aggregated.
From the result obtain, it is quite clear that their strength are not the same,
The result also reflect the strength of aggregate since their strength can be directly determined.
The finishing from these works show the strength of these aggregates and also reflect the standard of work that these aggregate can be used for concreting.
INTRODUCTION
This work was obligated to present in one. The fundamental and practical information in the filed of the comparative analysis of the strength of concrete made from various aggregate which may be useful to people involve in civil and structural engineering and particularly, those that found pleasure in the design and related structure.
Due to high cost of sand in the market the comparative analysis of strength of concrete made from various aggregate play an important role in cost of transportation, thus the cost of material.
Enugu state case a case study has quite an abundance of washed gravel, which are usually picked out from stream, black and surface gravel present in every part of the state though, in many construction sites, mostly within Enugu metropolis crushed/granites stones got from Abalikik and Nkalagu are mostly used, in the rural areas, washed gravel are mostly used because of its availability and cheapness compared to crouched stones.
The aim of this project therefore, is to compare the compressive strength produced b those washed, black, surface and granite stone got from different areas and to see if there is any way, these coarse aggregate can be interchanged during construction especially when her is shortage of any one of the materials.
LITERATURE REVIEW
Teychene D/C2, published the results of investigation at the building research establishment on crushed rock aggregates in concrete in 1978.it appears that the performance of concrete made with a particular aggregate could not be assessed from standard test on the aggregate it was suggested that to asses its performance concrete should be made with the aggregate and shrinkage and absorption characteristics measured.
Madu R.M of the University of Nigeria, published his work on the “performance of lateitic aggregate and road chippings in 1980. this paper studies the properties relevant to the use of laterictic aggregates road chipping, and concrete aggregates and compared the results to those obtained by the use of an igneous control aggregate.
The strength growth pattern of concrete made with lateritic stones, the variation of the tensile strength of the concrete (both flexural and split) the reproductively of the strength patterns and the influence of the iron and aluminum oxide contents for the aggregates on concrete made with them investigated in detail to assess the suitability of lateristic stones and crusts as concrete aggregates and road chippings.
Still on lateritic rocks, Gidigasu, MD revealed that through careful selection and identification using standard and modify aggregate testing procedures, some lateritic rocks could be accepted for use as concrete aggregates. The major limitation to their use .he emphasized appeared to be the potential long term deterioration in certain environment.
SIEVE ANALYSIS
This is method of dividing a sample of aggregate into fraction, each consisting of particles of the same size. In practice, each fraction contains particles between specific limits, these being the opening of a standard test sieve (B.S 410 of 1969) series for the purpose of testing and the procedure involve in making te sieve analysis also conform tote B.S standard.
Sieve analysis is made bypassing the dried aggregate through a series of test sieves beginning with the ones sufficiently coarse to pass all materials.
METHOD OR PROCEDURE
For the purpose of this analysis, the coarse aggregate were washed and allowed to surface-dry in the open air day. Attempt was made to obtain a representative samples of the aggregates by passing the materials in a set of sieves consisting usually of certain standard sizes.
Subscribe to access this work and thousands more