Electrical Electronics Engineering Research Papers/Topics

INVESTIGATION OF SUITABLE TIME FOR THE PERFORMANCE MEASUREMENT AND EVALUATION OF MONO-CRYSTALLINE PHOTOVOLTAIC PANELS AT FEDERAL UNIVERSITY OF AGRICULTURE, ABEOKUTA (FUNAAB), ALABATA, OGUN ST

Abstract  Human existence relies on solar energy either directly or indirectly and the world at large cannot continue to exist, remain or live without the solar energy. Solar power in Nigeria can serve as a source of sustainable energy if fully utilized due to abundant availability all year round energy and its regular appearance on daily basis in the sky under a friendly environment. The maximum output current and power of solar panel used in harvesting solar energy are obtained at sola...

Output Power and Voltage-Time Characteristics of Mono-Crystalline Photovoltaic Panel at Federal University of Agriculture, Abeokuta (FUNAAB), Alabata, Ogun State, Nigeria Under FUNAAB Weather

Abstract Solar energy is gaining more attention than ever before due to its potential ability to provide the world energy needed at a sufficient and reliable rate. Putting more focus on its optimum harvesting and utilization can eventually solve the problem of energy shortage by balancing up the energy demand of the nation. Adequate information on the output voltage of the solar panel to cope with the output current during the daytime is essential to be able to predict accurately the esti...

PERFORMANCE EVALUATION OF MONO-CRYSTALLINE PHOTOVOLTAIC PANELS IN FUNAAB, ALABATA, OGUN STATE, NIGERIA WEATHER CONDITION

Abstract The current-voltage characteristic is the basic descriptor of photovoltaic device and is used to test the performance of PV panel. The manufacture specifications on solar panels are obtained under standard condition (solar irradiance of 1000 W/m2, AM 1.5 and operating temperature of 25oC) which is not the real operating condition the solar panels are exposed to on the installation site. With this, the information obtained from the manufacture specifications would not be sufficient...

Design and Construction of a Power Inverter

ABSTRACT Power inverter is an electrical appliance that can be used with DC battery as an alternativesource of energy supply in the event of power failures and energy crisis. It is cheap, clean,very conducive and silent when in operation and a very reliable source of power supply as togenerator. Modern research and technologies have shown that inverter is one of the cheapestforms of energy generation. Throughout the world, it is readily available and can be partnerto solar energy particularly...

DESIGN AND CONSTRUCTION OF A MICROCONTROLLER BASED PREPARED ENERGY METER

BSTRACT Automatic door control is becoming popular due to its numerous benefits. Automatic door control refers to the control of doors and domestic features by just sensing the present of human being at door and automatically open the door with the persons interface or by remote control. Artificial Intelligence provides us the framework to go real-time decision and automation for Internet of Things (IoT). The work deals with discussion about different intelligent home automation systems and t...

AUTOMATED DOOR CONTROL SYSTEM WITH INTRUDER LOCK AND SMS NOTIFICATION

This work is on design and Construction of Automated door security system with GSM notification. Is an electrical Electronics Engineering Project.

DESIGN AND CONSTRUCTION OF HOME AUTOMATION USING WIFI

ABSTRACT This project presents a design and implementation of new advanced Securitypower control using Android power switch system that uses WiFi technology as anetwork infrastructure connecting its parts. The proposed system consists of twomain components; the first part is the server (web server), which presents systemcore that manages, controls, and monitors users’ home. Users and systemadministrator can locally (LAN) or remotely (internet) manages and control systemcode. Second part is ...

Contemporary Developments in HVAC (High Voltage Alternating Current) and HVDC (High Voltage Direct Current) Power Transmission Systems.

The project aim is to design an HVAC and HVDC transmission system using MATLAB simulation followed by testing the systems and running analytical results, reviewing their power transfer capabilities with reference to their operational performance under different situations in advent of their technological aspect. The aims and objectives of this project are:        I.            Describing HVAC and HVDC power systems with their composite topologies.     II.     ...

Micro Controller based smart under and over voltage Protection Device

This Project present the design and construction of a microcontroller based under and over voltage protection device, which is achieved using a microcontroller, transistor and other discrete components. A microcontroller PIC16F877A is at the heart of the device which performs the major control of the device. The device is simple and low cost. It can withstand loads of up to 2KVA, while allowing the supply Voltage to be connected load to vary from 200-240 volts.

A PHASE FAULT DETECTOR FOR POWER TRANSFORMER

ABSTRACT A power  transformer is a very  simple device. It  is a vital  link in the  electronic  distribution  system. A power transformer is associated with faults.  The design and construction of the phase fault detector is to provide simple, reliable and comprehensive electrical phase fault detections and response system. The system  includes  means for  detecting  any of the  various electrical  faults, such  as  impermissible  low voltage  levels, impermissible  high ...

2.5KVA AUTOMATIC VOLTAGE REGULATOR (AVR)

ABSTRACT The AVR is an automatic voltage regulator and it is a device which is used to regulate or stabilize electrical power supply for electrical or electronic appliances. Inthisprojecttherefore,weareinterestedintheconstructionof this allimportantdevice.Furthermore we shalldiscuses the techniques,processes,switching stages and then the working principleoftheautomaticvoltageregulator Chapteroneofthisprojectdwellsontheintroductionofthe projecttopic.Italsotalksabouttheobjectivesoftheproject,br...

Comparative analysis of internet performance over 3 sites with and without VPN

   ABSTRACT Nowadays, there is an increase in the demand to connect to the internal networks of organizations by their branches from distant locations. Members of such organizations often need to access internal networks from their homes, hotels or other far away business places and external networks over the internet which is insecure by virtue of its public nature. The security of information transferred in the network becomes a major challenge when staff or partners in business access in...

DESIGN OF SOLAR STREET LIGHT SYSTEM FROM UCC WEST GATE TO ELMINA

Content   Pages   DECLARATION ii ACKNOWLEDGEMENT iii DEDICATION iv TABLE OF CONTENT v CHAPTER ONE Introduction 1 1.1 Background of the Study 1 1.2 Problem of Study 2 1.3 Objectives of Study 3 1.4 Scope of Study 3 1.5 Significance 4 CHAPTER TWO Literature Review 5 2.1 Introduction 5 2.2 Types of Street Lights 6 2.3 Photovoltaic Effect/Process 9 2.4 Charge Controller 10 2.5 Inverters 10 2.6 Battery 10 CHAPTER THREE RESEARCH METHODOLOGY 13 3.1 Introduction 13 3.2 Research Design 13 3.3 Re...

Unmanned Aerial VehiclePitch Optimization for Fast Response of Elevator Control System

The flight dynamicsof an Unmanned Aerial Vehicle(UAV)is the science ofitsorientation and control in three dimensions.The three primary orientations include: the Pitch, the Roll and the Yaw. Therear part of the tailplaneis known as the elevatorcontrol ofanUAVpitch (therotating around the transversal axis). Flight route deviations and flight altitude variations due to hash weather conditions such as shock waves or thunder storm and the wind speed/direction during flight greatly affect the pitch...

Design of a Robust PID Controller for Improved Transient Response Performance of a Linearized Engine Idle Speed Model

One of the advantages of automatic control system is its application to the regulation of internal combustion engines. An area of significance in fuel energy reduction and efficiency improvement is the control engine idling speed. This paper has presented a control system for improved transient response performance of a linearized engine idle speed model. In order to realize the aim of the work, nonlinear dynamics of engine idle speed are obtained and were later linearized. A proportional int...


286 - 300 Of 515 Results