Engineering

Engineering Research Papers/Topics

Multiband reconfigurable antennas for 5G wireless and CubeSat applications: a review

Abstract: The rapid development of wireless technology has sparked interest in multi-band reconfigurable antennas as devices and satellites are innovating toward miniaturization. With limited space, reliable and efficient high bandwidth antenna systems are needed for current and next-generation wireless technology as well as for the revolutionary small satellites. The fifth generation of mobile communication technology promises high data rates, low latency and good spectrum efficiency. O...

Design simulation and analysis of a unified power flow conditioner for transmission line

Abstract: The reactive power compensation in power system is done by using different Flexible AC Transmission Controllers (FACTS). Unified Power Flow Controller (UPFC) is simulated and analyzed to observe its overall functions when integrated into a transmission line. It is installed in electric transmission lines hence assisting in the controlling and manipulating of the power flowing in the lines to give out reliable, controlled and efficient electricity to an ordinary consumer. The modell...

Structural, optical and electrical properties of undoped and co-doped Al/Ga ZnO thin films by spray pyrolysis

Abstract: Zinc oxide (ZnO) is a naturally occurring n-type semiconductor which is viewed as a promising candidate to replace indium tin oxide (ITO) in opto-electric applications, owing to its natural abundance and a wide bandgap (3.37). Synthesis of ZnO thin films via chemical spray pyrolysis technique is more convenient and cost effective compared to the mostly used deposition techniques such as magnetron sputtering which are highly expensive. Chemical spray pyrolysis provide easier way of ...

Meteorological influence on eLoran accuracy

Abstract: Stringent accuracy requirements need to be met for eLoran deployment in marine navigation and harbour entrance and approach. A good accuracy model is therefore required to predict the positioning accuracy at the user’s receiver locations. Accuracy depends on the variations of additional secondary factors (ASFs) and the primary factor delay. The changes in the air refractive index caused variations in the primary factor (PF) delay of the eLoran signal, and current eLoran accuracy ...

Modeling,simulation and energy management of solar PV-based Microgrinds using real-time residential data

Abstract: The research aims at defining and analyzing an energy solution that incorporates renewable energy, thereby giving rise to improving energy security and providing grid stability for the grid networks located in urban residential areas. The urbanization growth in Botswana coincides with the increase in electricity consumption. The electricity load demand in the country outlasts the local supply and thereby the need for importing electricity from the Southern Africa Power Pool (S...

Spectrum handoff in cognitive radio based smart grid network

Abstract: The Smart Grid (SG) as an intelligent power network, depends on a reliable and efficient communication network to provide two-way communication, which is a prime feature of the smart grid. Many researchers have proposed cognitive radio (CR) as a viable wireless communication technology that can be adapted for smart grid communication in order to improve spectrum utilisation and address communication challenges being faced by conventional wireless communication technologies. A major...

Optimum Course Association Method with Cloud Service Orchestration

Abstract: Negotiations in Cloud, Optimal path planning, Cloud Service orchestration Finest Trail Setup Technique in Cloud Ambience[1] proposes a fuzzy logic based SVM approach to secure a collision free path avoiding multiple dynamic obstacles. The navigator consists of an FSVM -Based Collision Avoidance. The decisions are taken at each step for the providers & consumers to negotiate without collision. Fuzzy-SVM rule bases are built, which requires simple evaluation data based on the active ...

Turbulent flow inside longitudinally corrugated pipes

Abstract: Longitudinally corrugated pipes can be described as pipes with periodically converging-diverging cross-area arranged along the flow course. These pipes are mainly utilized in engineering applications, for example, pipe flow in a heat exchanger where wall corrugation improves heat convection,gas to liquid contractors in the chemical business, ventilation, air conditioning, drag reduction and mass transfer efficiency. Both experimental and analytical works detailed the impact of c...

Electroosmosis modulated peristaltic biorheological flow through an asymmetric microchannel: mathematical model

Abstract: A theoretical study is presented of peristaltic hydrodynamics of an aqueous electrolytic non-Newtonian Jeffrey bio-rheological fluid through an asymmetric microchannel under an applied axial electric field. An analytical approach is adopted to obtain the closed form solution for velocity, volumetric flow, pressure difference and stream function. The analysis is also restricted under the low Reynolds number assumption (Stokes flow) and lubrication theory approximations (large wavele...

Investigation of cu2znsns4 (caus) nanostructured material system for energy conversion

Abstract: Photovoltaic technology is a very crucial technology and it is gradually growing worldwide as there is plenty of sunshine daily especially in African countries. The aim of photovoltaic technology is to generate electricity from solar power using photovoltaic devices like solar (photovoltaic) cells. Photovoltaic cells are mostly used to provide electricity in rural areas which are not connected to the national grid like farms (cattle posts). In this work superstrate CZTS solar ce...

The carbonate-catalyzed transesterification of sunflower oil for biodiesel production: in situ monitoring and density functional theory calculations

Abstract: Biodiesel has emerged as a promising alternative fuel to replace dwindling fossil-based resources, particularly in view of its added environmental merit of reducing additional air pollution. Its specific attraction stems from the similarity of its physical properties to fossil fuel-derived diesel. Although the production of biodiesel is a relatively straightforward process, reaction progress monitoring and product analysis require costly specialist equipment, such as gas chromatogr...

Hydrothermal and entropy production analyses of magneto-cross nanoliquid under rectified Fourier viewpoint: a robust approach to industrial applications

Abstract: The present article has been groomed to explore the boundary-driven magnetized flow of cross nanoliquid over thin needle subject to auto catalysis chemical reactions. In addition to it, the effect of entropy optimization model is incorporated and transportation of heat under non-uniform heat source/sink, Cattaneo-Christov heat flux (rectified Fourier) viewpoint (CCHF), and non-linear thermal radiation is also taken into account. Furthermore, the Brownian and thermophoresis aspects ...

Interfacial layer and shape effects of modified Hamilton's Crosser model in entropy optimized Darcy-Forchheimer flow

Abstract: In this analysis, the interfacial layer and shape effects has been inspected numerically for the Darcy Forchheimer electromagnetic flow of single-walled carbon nanotubes (SWCNT) and multi-walled carbon nanotubes (MWCNTs) with base fluid (water) nanofluids. The influence of nonlinear thermal radiation and homogenous and heterogeneous chemical reactions are also taken into account. A revised Hamilton Crosser model is implemented for measuring interfacial layer and shape effects of ca...

Determining real permittivity from fresnel coefficients in GNSS-R

Abstract: Global Navigation Satellite System Reflectometry (GNSSR) can be used to derive information about the composition or the properties of ground surfaces, by analyzing signals emitted by GNSS satellites and reflected from the ground. If the received power is measured with linearly polarized antennas, under the condition of smooth surface, the reflected signal is proportional to the modulus of the perpendicular and parallel polarization Fresnel coefficients, which depend on the incidenc...

Magnetic field effect on a fractionalized blood flow model in the presence of magnetic particles and thermal radiations

Abstract: The presence of magnetic particles is considered in a magneto-hydrodynamic blood flow through a circular cylinder. The fluid inside the tube is acted by an oscillating pressure gradient and an external constant magnetic field. The blood temperature is assumed to change with the blood and particle velocities, and the whole study is based on a mathematical model that includes Caputo fractional-order derivatives. Solutions for the particle and blood velocities, and blood temperature d...


121 - 135 Of 3416 Results